Download Print this page

Advertisement

Quick Links

SCARAB M25H ROAD SWEEPER - Abbreviated Operating Instructions
Main Control Panel
Sweep mode
Front brush water*
Front brush*
Left suction
Left side brush
Left work light
Engine speed -
Left water
Option*
Central brush
(wide sweep) water
Auxiliary Control Panel
Cruise control
High pressure
water pump
Nozzle tilt locked
Favourite setting
Multi-function lever
* = Option
Option*
Sweep mode
Central brush
(wide sweep)
Right suction
Suction fan
Right side brush
Right work light
Engine speed +
Right water
Option*
* = Option
Suction fan
Not applicable
LEVER UP (OFF), Stop and raise all sweeping
equipment.
LEVER MIDDLE (ON), Deploy all selected
sweeping equipment.
LEVER RIGHT, right front brush OUT/IN.
LEVER LEFT, left front brush OUT/IN.
LEVER DOWN (NOZZLE TILT)
For a temporary nozzle tilt pull lever back and
hold to OPEN.
Release the lever to CLOSE.
OFF
Left
Right
ON
front
front
Press and hold down the Safety Interlock and the
brush
brush
appropriate control switch.
For safety reasons only operate the Remote
Control from outside the vehicle, from a vantage
Nozzle
point that affords a good view of the sweeper and
tilt
its surroundings.
Normal drive mode
Main on-screen information
and warning symbols
No unauthorised or untrained personnel to operate this sweeper.
1. Select Neutral (Yellow Control Lever). Handbrake ON. Sweep Mode
switch OFF. Multi-function lever OFF. Start Engine.
2. Select Forward or Reverse (Yellow Control Lever).
Hopper
Hydraulic oil
3. Release handbrake, press accelerator pedal to move the vehicle.
ON
not down
low
Sweep mode
4. Stop vehicle. Handbrake ON.
5. Sweep Mode switch ON. Engine RPM changes to pre-set level.
Hydraulic oil
Water tank
level low
temperature
6. Select the desired sweeping equipment. Switch on Suction Fan.
ON
Suction Fan speed (2000 RPM). Use Engine speed controls to change RPM if required.
7. Multi-function lever ON, beacons ON.
H-P water pump
Service
8. Select FORWARD (Yellow Control Lever). Handbrake OFF, depress accelerator pedal to move
reminder
vehicle.
All sweeping equipment will stop and raise when REVERSE is selected, and re-engage in
FORWARD.
H-P water pump
Active fault
no water
present
Cruise control (only in sweep mode)
9. With vehicle at the desired speed, select Cruise Control. Can be over-ridden by the
Remote Control
accelerator pedal, and is cancelled by using the foot brake or by pressing the switch.
When sweeping with a full load or up-hill, engine RPM may need to be increased.
Vehicle movement is controlled, by means of the accelerator and brake pedal, similar to a
vehicle fitted with automatic transmission.
Never press brake and accelerator pedals at the same time.
LCD Screen
Main equipment colour codes
Equipment not selected
Equipment pre-selected
Equipment operating (active)
Water pre-selected
= Safety interlock
Equipment and water pre-selected
= Option*
= Raise hopper
= Lower hopper
= Open rear door*
= Close rear door*
* = Option
This document is designed as a quick reference guide, to allow the operator to drive the vehicle
in Normal or Sweep Mode and operate the basic controls. It does not constitute the full
operating instructions.
Central brush (wide sweep)
water ON
F1
F1
Water ON
Side brush active
Work light ON
Sweep mode ON
NOTE: LCD screen is shown with the majority of icons shown to give a representation
of what could be visible and is not what would be visible in normal use.
Please refer to reverse for health and safety advice
Forward
Neutral
Reverse
Time
Engine RPM
12:34
1267
F2
F2
F3
F3
Suction active
Cruise control ON

Advertisement

loading
Need help?

Need help?

Do you have a question about the M25H and is the answer not in the manual?

Questions and answers

Summary of Contents for Scarab M25H

  • Page 1 SCARAB M25H ROAD SWEEPER - Abbreviated Operating Instructions Main Control Panel Sweep mode Normal drive mode Main on-screen information * = Option and warning symbols No unauthorised or untrained personnel to operate this sweeper. Option* 1. Select Neutral (Yellow Control Lever). Handbrake ON. Sweep Mode Front brush water* switch OFF.
  • Page 2: Health And Safety

    Health and Safety Z043459 - Version 1.1.2 - English • Only trained operatives should be allowed to drive or work on this machine. Hopper safety prop • Never work under a raised hopper, rear door or cab without the appropriate safety prop in position. •...