G.angle Adjustable Footplates; H.backrest; Angle Adjustable Backrest - Sunrise Medical Wheelchair Quickie 2 Lite Owner's Manual

G. ANGLE ADJUSTABLE FOOTPLATES
1. Composite Angle Adjustable Footplates
a. Remove bolt (A)
b. Pull footplate section (B) away from extension.
c. Reposition footplate back onto extension in new angular position. Use premarked extension
coupling (C) as guide.
2. Aluminum Angle Adjustable Footplate
a. Loosen bolts (D).
b. Adjust footplate (E) to desired angular position.
c. Re-tighten bolt (D).
12
H. BACKREST
1. Height Adjustment
a. Remove the backrest upholstery from the frame.
b. You will see the backrest tube which telescopes into the frame and is secured by a screw (F) on
the side of the frame.
c. There are holes 1 inch apart that you may choose from to set the back height.
d. Remove the two backrest bolts from the rear frame tubes.
e. After selecting the proper height, insert bolt through frame and backrest tube.
f. Slide the backrest upholstery back over both backrest tubes.
I. ANGLE ADJUSTABLE BACKREST (OPTIONAL)
13
1. Angle Adjustment
a. Loosen button head screws (G) until the eccentric offset washer (H) moves freely.
b. Adjust backrest to desired angle, aligning eccentric offset washer in slot.
c. Tighten button head screws.
d. Repeat for opposite side.
2. Pivot Point Height Adjustment
a. Remove button head screws (I) from the frame.
b. Adjust backrest to obtain desired pivot point height.
c. Replace and tighten button head screws.
d. Repeat for opposite side.
3. Backrest Height Adjustment
a. Remove button head screw (J).
b. Adjust back tube to desired height.
c. Replace and tighten button head screw.
d. Repeat for opposite side.
10
11
14
15
15
10
B
C
A
11
D
E
12
F
13
G
H
14
I
15
J
I X .
108590 Rev. A