Device Specific Information; Installing The Module; Connecting The Input Signals - National Instruments SCC-DI01 User Manual

Device Specific Information

For general SCC module installation and signal connection information, and
Note
information about the SC-2350 carrier, refer to the SCC Quick Start Guide, available
for download at

Installing the Module

Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.

Connecting the Input Signals

Note The signal names have changed. Refer to
to confirm the signal names.
© National Instruments Corporation
.
ni.com/manuals
Plug the SCC-DI01 into any digital input/output socket J(X+9), where X is
0 to 7, on the SC-2345. When you follow the procedure in the SCC Quick
Start Guide, the SC-2345 routes the digital input signal to channel P0.(X)
on the E Series DAQ device.
Signal SCC-DI01
Source
V
2
IN
3.3 kΩ
+
1/2 W
–
V
1
COM
Figure 1. SCC-DI01 Signal Connections
For information about how to configure the SCC-DI01 module using
NI-DAQmx, refer to the SCC Quick Start Guide.
ni.com/info
+5 V
3 SCC-DI01 Isolated Digital Input Module User Guide
and enter
rdtntg
E Series
Status
LED
P0.( X )
D GND