When Used As The Master Machine For The Transverter - Kenwood TS-850S Instruction Manual

4-19. When used as the master machine for the transverter
Notes
1. Be sure to unplug the DC power cable before starting work.
2. Advanced skills and knowledge will be needed for this type of operation. Be very careful to make
connections exactly as shown.
Shield cover
• CONNECTION
I='" ":1
REMOTE connector
From standby switch
(PTT circuit for foot switch)
+
1 2 VDC ON transmit
max. 10 rnA
•Preparation
1. Removing the bottom cover from the transceiver.
2. Removing the shield cover.
3. Disconnect the plug of the coaxial cable from CN26,
and insert it into CN25.
4. Replace the shield cover and the bottom cover.
Note
Avoid pinching the wiring harness when closing.
The IF OUT 1 terminal on the rear can be used as a
drive out terminal.
Note
IF OUT 1 cannot be used as an output terminal for a
bandscope .
,--------------.....,
From the converter output
Transverter
+B
J;
.OI,uF
When 8 to 12 V is externally applied
to
+
B, the relay in the set operates,
and 0-10 dBm can be output from
A during transmission.
When connections are made as shown above, the PWR control on this unit does not work, so turn it fully
clockwise. The external ALC input is negative. The ALC circuit operates from about -9 V.
49