Kenwood TS-850S Instruction Manual page 47

B. Split Memory Channel
1.
Select the receive frequency, the mode and the
filter.
Example:21.200 MHz is selected on VFO A.
l-
J
I
J ,-, ,-, ,-,
lr
'· L
u u. u u
kHZ
USB
2. Press the A=B key.
3. Set the RX VFO to B and select the desired
transmit frequency.
Example:21.210 MHz is selected on VFO B.
-, I -,
c
I.C
,-, ,-, ,-,
U.U
u
kHZ
4. Set the RX VFO to A and set the TX VFO to B.
Indicate the SPLIT display. When the TX VFO B
key is pressed, the transmit frequency is
displayed momentarily. This momentary display
may be suppressed with the function setting at
power on. (Please refer to Section 4-10-15.)
-, I -, lr ,-, ,-, ,-,
c
I.
c
u u. u
Ll
kHZ
USB
5. Press the M.IN key.
M. CH
114. SCR
1 - , - ,
ILl 1,-,C",-,,-,
Ll
.J
I '· I I
J.
u
Ll
kHZ
USB
(When 14.175 MHz is stored in Memory Channel 03.)
6. Select the desired Memory Channel number.
I
"
CH
1n
I
u
kHZ
(When Memory Channel 10 is empty.)
7. When the desired memory channel is found and
displayed, press the M.IN key again. The current
frequency, mode and filter will be stored, the
Memory Scroll mode will be canceled. The transceiver
will return to the operating mode and frequency that
was displayed before the M.IN key was pressed ini-
tially.
SPLIT
J
I -, ,-, ,-,
lr lr
L
I.
c
u
Ll.
u u
kHZ
USB
38
C. Programmed Scan Memory Channel
The highest and lowest frequency are stored in this
memory channel. This channel can be used as a
standard memory channel if the highest and lowest
frequencies are identical.
1. Select the lowest operating frequency and the
mode.
Example:? .030 MHz is selected on VFO A.
,-, ,-, -, ,-, ,-, ,-,
I.
u
J
u.
L#
u
kHZ
L SB
2. Press the A=B key.
3. Select the highest operating frequency.
Example: 7.100MHz is selected on VFO B.
,-,
,-, ,-, ,-, ,-,
'• u u.u
U
kHZ
LSS
4. Press the RX-A key and Press the M.IN key.
I 1-1
lJ
I -, ,-, ,-, ,-, ,-,
I
u - '·
c
Ll
u.
Ll
u
kHZ
USB
(When 21.200 MHz (RX) and 21.210 MHz (TX) are stored in Memory
Channel 1 0.)
5. Select the desired Programmed Scan Memory
Channel number (90-99ch).
kHZ
(When Memory Channel 90 is empty.)
6. When the desired program scan memory channel
is found and displayed, press the M.IN key again.
The current frequency, mode and filter will be
stored, the Memory Scroll mode will be canceled,
and the transceiver will return to the operating
frequency that was displayed before the M.IN key
was pressed initially.
,-, ,-, J ,-, ,-, ,-,
f.
u -' u. u
U
kHZ
L SB