Kenwood TS-850S Instruction Manual page 52

Note
If the CLR key is pressed during recording, the
recorded data is erased.
5. When the REC key is released, recording is
terminated, and the normal receive mode returns
automatically.
Note
If the available time is used up during recording,
recording is terminated, and the normal receive
mode returns automatically.
2. Playback method
1. Select the receive mode.
2. Set the VOX/MAN switch to MAN.
3. Press the PLAY key for the desired channel to
start playback. Adjust the volume with the MONI
control.
Example:
I - -
4. When the playback ends, the transceiver returns
to its normal state.
Note
When the CLR key is pressed during playback,
the transceiver returns to its normal state.
3. Transmitting a message
•From the receive mode
1. Set the VOX/MAN switch to VOX.
2. Press the PLAY key for the desired channel to
start transmission. For information about the
microphone gain adjustment, see the SSB or AM
transmission section.
3. When the transmission is complete, the receive
mode will return automatically.
•From the transmit mode
Press the PLAY key for the desired channel to start
transmission.
To transmit recorded voice without delay, switch
VOX off or turn the GAIN control on the rear of the
radio fully counterclockwise.
4. Continuous playback
Up to three channels can be played back
continuously.
Example: When PLA Y1, PLA Y2, and PLA Y3 are
pressed successively during playback.
I
2 3
44
When PLA Y1 transmission is complete.
23-