Summary of Contents for Cervis SmaRT BU-x18XF Series
Page 1
™ ™ SmaRT BU-x18XF and BU-xH18XF Base Units User Manual U069.3.3 2019 Cervis, Inc.
Page 2
SmaRT BU-x18XF and BU-xH18XF This document is the property of Cervis, Inc. and cannot be copied, modified, e-mailed, or reproduced without the express prior written consent of Cervis, Inc. Cervis, Inc. reserves the right to change this manual or edit, delete, or modify any information without prior notification.
Notes—such as the following example—provide information that may be useful to the user or are pertinent to system operation. Note: Cervis-provided harness wires are either color-coded or individually numbered to aid in properly wiring the controlled devices to the P1 and P2 base unit connectors. U069.3.3...
When carrying out repairs, only use parts supplied by Cervis, Inc. dealers. 1.2 What You MUST NOT Do Never make changes to the system that have not been studied and approved by Cervis, Inc. Never power the equipment with anything other than with the specified power supply.
Page 6
SmaRT BU-x18XF and BU-xH18XF Never use the system if failure is detected. U069.3.3...
Diagnostic LEDs +7 to +28VDC power Compact design Rugged, weatherproof construction Communicates with up to eight SmaRT remotes Optional RS-232 models for SmaRT Connect use (see Table 1, Figure 3, or Table 2) 2019 Cervis, Inc.
When mounting the base unit and connecting the wiring harnesses, use the configuration diagrams supplied by Cervis, Inc. as a guide. Dimensions for drilling mounting holes are shown in Figure 2. Wiring diagram and connector pinout is shown in Figure 3.
Associate process, which can also be easily performed on site when necessary using the SmaRT remote control unit. Associate processes for each remote control unit are described in detail in each SmaRT remote manual and Cervis, Inc. Engineering SpecSheet. PG-xH14-DIS...
Associate mode varies depending on the type of SmaRT remote control unit the base unit is to communicate with. Please reference the appropriate SmaRT remote control manual or Cervis, Inc. Engineering Spec Sheet for complete Associate Mode details.
0–10V or M17(Ch17) P1–2 M18 (Ch18) P1–11 4–20mA (factory configurable) Optional Umbilical CAN Bus SAE J1939 Communications Only units marked with –SC are RS-232 capable (CAN is not SmaRT Connect See Table 1 available) allowing SmaRT Connect use. 2019 Cervis, Inc.
1A draw is a normal condition.) Health LED (LED 1) Indicates an internal problem. Contact Cervis, Inc. service department. blinking rapidly † – If the recommended solutions do not resolve the issue, contact the Cervis, Inc. service department. U069.3.3...
2. Keep the remote control unit at least 15mm (⅝ inch) away from the body, and only use carrying cases, belt clips, or holders that are approved by Cervis, Inc. When active, a SmaRT base unit sends out RF through its external antenna. Base units using an external antenna should be mounted to ensure that the antenna is at least 20cm away from the human body.
SmaRT BU-x18XF and BU-xH18XF Appendix C: BU-2H18XF Declaration of Conformity U069.3.3...
Page 17
Base Unit Manual www.cervisinc.com. Visit our Web site at Phone: (724) 741-9000 Fax: (724) 741-9001 2019 Cervis, Inc. All rights reserved. Content is subject to change without notice. Revised manuals are available for download at www.cervicinc.com. 2019 Cervis, Inc.