Program Filtration Cycles/Filtration Duration; Establishing Correct Water Chemistry - COLDTUB Icekube Owner's Manual

54
3.10.3 Program Filtration Cycles/Filtration
The system will automatically perform 4 one hour filtration cycles per day, 6 hours apart. The
above system factory filtration settings can be adjusted by the consumer through:
• onTub power management using your device such as smart phone or tablet that has been
connected to your Tub through WiFi. Refer onTub user Guide.
• The settings. Refer COLDTUB COLDTUB Owners Manual.
3.10.4 Establishing Correct Water
The following steps provide guidance to help establish correct chemically balanced water.
To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the
chemical in an uncontaminated container of hot water before adding to the Tub water.
Steps to Establish Chemically Balanced Water With COLDTUB Pal
Winning is cool™
Duration
Chemistry
Step 1. Test and Adjust Total Alkalinity
Test Total Alkalinity. It should be 80 – 100 ppm (100 max). If high,
lower Total Alkalinity with
Down) or muriatic acid. Do not raise Total Alkalinity!
WARNING: Skipping this step on Start-up can cause scaling
problems and cloudy water that may not be covered under warranty.
NOTE: Use all products according to directions on the bottle.
Step 2. Test and Adjust pH
Test pH. Levels should be between 7.0 – 7.6.
If pH is high, (over 7.6) add
NOTE: Use all products according to directions on the bottle.
NOTE: Salt systems naturally drive pH levels to increase, strive to
achieve a Balanced pH level.
NOTE: High pH will cause calcium to precipitate (fall out of
suspension). The problem with calcium falling out of suspension is
that it collects on the heater and pump, and shortens their life.
Step 3. Mix Salt Crystals
Dissolve the required recommended salt dosage in a 5 Gallon
(20 litre) pail of hot water.
Pal Salt Dosage Chart contained in this guide.
Step 4. Add Salt to Tub Water & Re-Test TA / pH
(a) Slowly pour the dissolved salt from the pail into the Tub water.
(b) Run pumps for 5 minutes to help mix salt blend through.
(c) Wait 1 hour.
(d) Then re-test and adjust Total Alkalinity level accordingly.
(e) Then re-test and adjust pH level accordingly.
Refer: Steps 2 and 3 for correct TA/pH levels
COLDTUB Cold Water Run Down
COLDTUB Cold Water Run Down.
(pH