Fill Tub With Water Power Up Tub And Set Water Temperature - COLDTUB Icekube Owner's Manual

3.10.2 Fill Tub With Water Power Up Tub and
Fill Spa With Water Power Up Spa and Set Water
1.14.2
Set Water Temperature
Temperature
The following steps provide guidance to help establish correct chemically balanced water.
The following steps provide guidance to help establish correct chemically balanced water. To help
To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the
ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the chemical in an
chemical in an uncontaminated container of hot water before carefully adding to the spa
uncontaminated container of hot water before carefully adding to the Tub water.
water.
Note: The following steps take into account that your Tub has water above the COLDTUB Pal Sensor
Housing, removed the COLDTUB Pal Sensor Plug, installed the COLDTUB Pal Sensor Housing Grate
Note: The following steps take into account that the Spa Technician has filled your spa
and installed the COLDTUB Pal Sensor.
with water to above the Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug,
installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.
WARNING
: Do not proceed until your Tub water is above the COLDTUB Pal Sensor Housing,
Warning:
removed the COLDTUB Pal Housing Plug, installed the COLDTUB Pal Sensor Housing Grate
and installed the COLDTUB Pal Sensor. or you have obtained further direction from your
Dealer.
Steps to Fill Tub With Water Power Up Tub and Set Water Temperature
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Do not proceed until the Spa Technician has filled your spa with water
to above the Spa Boy Sensor Housing, removed the Spa Boy Housing
Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa
Boy Sensor. or you have obtained further direction from your Dealer.
Step 1. Fill Spa
Fill your spa through the filter intake as shown to the
appropriate level (just under the head rests). If you have
STEP 1. FILL TUB
sediment or high mineral content a "carbon filled pre-filter",
as pictured, can help. (This is optional and will prolong
Fill your Tub through half way up the skimmer box as shown
the fill time).
to the appropriate level.
Step 2. Connect/Turn on Electrical Power to the Spa
STEP 2. CONNECT/TURN ON ELECTRICAL POWER TO Once the spa is filled to the proper level, connect power to
the spa in accordance with the Arctic Spas Owners Manual,
THE TUB
and turn the power on to the spa on.
Once the Tub is filled to the proper level, connect power to the
Tub in accordance with the COLDTUB Owners Manual, and
turn the power on to the Tub on.
STEP 3. SET WATER TEMPERATURE
Set the water temperature control on the settings to the
desired temperature (between 42ºF and 104ºF or 5.5°C and
40°C).
Spa Boy Owners Manual
Spa Boy Owners Manual
Version 1 Revision 1 (R1)
53