Patented Motion Smart Auto-Off; Anti-Calcium System (Select Models Only) - Sunbeam 4061 User Manual

Patented MOTION SMART
When the iron is plugged in, the Power Indicator
will light steadily, indicating that there is power
to the iron.
If you leave the iron:
• in a horizontal position without moving it,
or accidentally tip the iron over, it will
automatically stop heating after 30 seconds.
The Power Indicator will blink to let you know
that the iron has stopped heating.
• in a vertical position (on its heel rest) without
moving it, the iron will automatically turn off
after 15 minutes. The Power Indicator will
blink to let you know that the iron has stopped
heating.
Important: The Power Indicator will continue
to blink until the iron is unplugged or reset.
To reset the iron:
Move the iron back and forth and allow it to
reheat for 2 minutes. The indicator will stop
blinking and the iron will start heating again.
WARNING: The patented MOTION SMART
is a safety feature, not a recommended means for
turning your iron off. See "Caring for Your Iron After Use"
on Page 8, for information on turning off your iron
and storing it safely between use.
Anti-Calcium System
The Anti-Calcium System is a permanent system
located inside the water reservoir. This system
removes calcium from the water and reduces
calcium build-up on the soleplate.
features
®
Auto-Off Feature
(Select models only)
®
Auto-Off
7