Installation; Operating Environment; Power Supply - Sony BVE-700 Installation Manual

1-1. Operating Environment

Operating guaranteed temperature :
Performnace guaranteed temperature : +10 dC to +30 dC
Operating humidity :
Storage temperature :
Mass :
Prohibited locations
. Areas where the unit will be exposed to direct sunlight or
any other strong lights.
. Dusty areas
. Areas where it is subject to vibration.
. Areas with strong electric or magnetic fields.
. Areas near heat sources.
. Areas where is subjected to electricity noise.
. Areas where is subjected to static electricity noise.
Ventilation
The inside of the BVE-700 is cooled by a fan (rear and
sides).
The power supply can be damaged if the exhaust vent (rear
panel) and air intake (front panel) are blocked or the fan is
stopped.
Therefore, leave a blank space of more than 10 cm in the
front and back of the BVE-700.

1-2. Power Supply

1. Power specifications
A switching regulator is used for the power supply of this
unit. The voltage within the range of 100 V to 240 V can
be used without changing the supply voltage.
Power requirements : AC 100 to 240 V ± 10 %
50/60 Hz
Current consumption : Maximum 2.5 A
(with all optional boards installed)
n
As the inrush current at turn-on is the maximum 25 A (at
100 V/50 A (at 200 V), the capacity of the AC power must
be commensurate in it.
If the capacity of the AC power is not the adequately large,
the breaker of the AC power at the supply side will operate
or the unit will abnormally operate.
BVE-700

Installation

2. Recommended Power Cord
w
+5 dC to +35 dC . The power cord is not supplied with the BVE-700. Be
sure to use the power cord that is applicable to places in
10 % to 90 %
the area.
(relative humidity)
To avoid a fire or an electric shock, be sure to use the
_20 dC to +60 dC
designated power cord.
10 kg
. Do not damage the power cord.
Otherwise, a fire or electric shock may result.
Required Parts for the U.S.A. and Canada
1 Power cord : !1-551-812-11
Required Parts for Europe
1 Power cord : !1-782-929-21
1
1
AC inlet
AC inlet
1-1 (E)