Direct Z1-Ch3 (Input) - Kenwood TK-7160 Modification Information

1.3.12 Direct Z1-CH3 (Input)

Direct Z1-CH3 (Input) can be assigned to Port 1 to
Port 8.
The transceiver migrates to Zone 1 - Channel 3 when
the port logic level goes Low.
Direct Z1-CH3 (Input) is different from using the
Channel Up or Channel Down key, and Zone -
Channel is not stored as the Last Selected Channel.
1.3.13 Direct Z1-CH4 (Input)
Direct Z1-CH4 (Input) can be assigned to Port 1 to
Port 8.
The transceiver migrates to Zone 1 - Channel 4 when
the port logic level goes Low.
Direct Z1-CH4 (Input) is different from using the
Channel Up or Channel Down key, and Zone -
Channel is not stored as the Last Selected Channel.
1.3.14 Data PTT (Input)
Data PTT (Input) can be assigned to Port 1 to Port 8.
The transceiver migrates to a Data Channel when the
port logic level goes Low.
Data Channel can be configured in the Optional
Features window > Common Page 1 tab > Data
Zone-CH dropdown list.
The receiving party's transceiver does not emit any
data sounds when Data Transmit with QT/DQT is
disabled since the QT/DQT configured for the channel
is not valid.
1.3.15 Status Message (Input)
Status Message (Input) can be assigned to Port 1 to
Port 8.
The transceiver sends a FleetSync Status Message
depending on the port logic.
Status Message (Input) can be configured in the
FleetSync window > Target tab.
MOD (K)/Ver. 2.00
1.3.16 Speaker On (Input)
Speaker On (Input) can be assigned to Port 1 to
Port 8.
Speaker Amplifier is enabled while the port logic level
is Low.
1.3.17 AUX (Output)
AUX (Output) can be assigned to Port 1 to Port 8.
The logic level can be toggled between High and Low
by using the AUX key.
With this function, a control board prepared by a third
party or external devices can be controlled by using
the transceiver keys.
1.3.18 Tone Operated Relay
(Output)
Tone Operated Relay (Output) can be assigned to
Port 1 to Port 8.
The port logic level goes Low when QT/DQT is
detected.
The port logic level goes Low when QT/DQT is
detected on a channel where QT/DQT Decode is not
configured.
1.3.19 Carrier Operated Relay
(Output)
Carrier Operated Relay (Output) can be assigned to
Port 1 to Port 8.
The port logic level goes Low when a carrier is
detected.
This function can be used for KDS-100 and KGP-2A/
KGP-2B.
KDS-100 and KGP-2A/ KGP-2B recognize whether the
transceiver is receiving or not by checking the status of
this port.
Confidential
1 PORT FUNCTIONS
CONTENTS
7