Acura 2009 TL Owner's Manual page 603

Main Menu
Fuses
Checking and Replacing Fuses
If something electrical in your
vehicle stops working, the first thing
you should check for is a blown fuse.
Determine from the chart on pages
603 604 , and 605 , or the diagram on
the fuse box lid or the fuse label,
which fuse or fuses control that
component. Check those fuses first,
but check all the fuses before
deciding that a blown fuse is not the
cause. Replace any blown fuses and
check if the device works.
1. Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
Models equipped with the keyless
access system have an engine
start/stop button instead of an
ignition switch. VEHICLE OFF
(LOCK) Mode is the equivalent of
LOCK (0). See page 180
ignition switch and power mode
comparison.
600
Table Of Contents
FUSE
2. Remove the cover from the fuse
box.
3. Check each of the large fuses in
the under-hood fuse box by
looking at the wire inside.
Removing these fuses requires a
Phillips-head screwdriver.
for
BLOWN
2009 TL
BLOWN
Also check the combined fuse box in
the under-hood fuse box.