Cleaning The Seat Belts - Acura 2009 TL Owner's Manual

Main Menu
Lights, Cleaning the Seat Belts
BULB SOCKET
4. Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker.
5. Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
564
Table Of Contents
Push a new bulb straight into the
6.
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
7. Test the new bulb to make sure it
works.
Reinstall the trunk lining. Make
8.
sure it is installed under the edge
of the trunk seal.
9. Put the holding clip into the hole
on the side of the trunk lining.
Reinstall the screw.
2009 TL

Cleaning the Seat Belts

If your seat belts get dirty, use a soft
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry before
you use the vehicle.
OPENING