Table of Contents
Advertisement
How to prepare the unit for
operation
You can use the device to the normal power supply (230 V ~
/ Connect 50 Hz). The heat generated during operation must
be ventilated with sufficient air circulation. Therefore, the
device should not be covered or placed in a closed cabinet.
Provide a clearance of at least 10 cm around the unit.
How to improve the antenna
reception
The number and quality of available stations depend on the
reception conditions at the installation site. With DAB / FM
telescopic antenna (4) may be a useful reception are achieved.
Note:
Should be for the reception of digital radio stations
(DAB), DAB / FM telescopic antenna (4) are positioned
absolutely in the full length.
As you insert the batteries
Rotate the device so that the battery compartment
Open (20) at the bottom of can. See page 4
•
For battery operation, you will need 8 alkaline
batteries, type BABY, 1.5V, LR14 / C (not included).
When you put the correct polarity. See chart in the
battery compartment.
•
Close the battery cover carefully so that the
tabs holding the cover engage the chassis.
Note:
It should be taken to use only batteries of the same type.
Never mix old and new batteries.
Use leak-proof batteries!
Important notice for disposal
Batteries may contain toxic substances that damage the
environment.
Dispose of the batteries in accordance with the
applicable statutory provisions for you. Do not throw the
batteries in your household rubbish.
Advertisement
Table of Contents
