Front Panel Controls - Fresenius Medical Care 2008T Calibration Procedure

1.3

FRONT PANEL CONTROLS

The front panel consists of four areas, the display screen, the keypad, a full keyboard and a
touchpad. The display screen is the area under the glass in the center of the front panel. The
keypad is to the right of the display screen and contains membrane keys. Figure 2 illustrates
these areas. Note the keyboard and touchpad fold down 90 degrees from under the display
screen and keypad and are unable to be seen in Figure 2.
Keyboard
Throughout the calibration procedures, whenever a key is to be pressed, the appropriate
key name is surrounded by square brackets as in the following example:
In this example, the CONFIRM key on the touchpad should be pressed.
2
Use of the touch screen in Dialysis Mode is limited to Functional board software version 2.30 or greater or by having the touch screen
activated in Functional board software version 2.13 using a special feature chip.
Press the [CONFIRM] key and the screen will change.
2008T Calibration Procedures
Figure 2 - 2008T Front Panel
P/N 508032 Rev. H
Display Screen
With Integrated Touch Screen
Keypad
Touchpad
([CONFIRM] and
[Escape] keys are
located here)
2
Page 6