Placement Within The Shop / Establishing A Safety Zone - General 15-150 Setup And Operation Manual

PLACEMENT WITHIN THE SHOP / ESTABLISHING A SAFETY ZONE

This sander is heavy. Do not over-exert. The help of an assistant will be needed for the following step.
To limit the risk of serious injury or damage to the machine, any equipment used to lift this machine (forklift or lift-
ing hook) should have a rated capacity in excess of 570 lbs (259 kg).
PLACEMENT WITHIN THE SHOP
This machine should be installed and operated only on
a solid, flat and stable floor that is able to support the
weight of the sander (570 lbs/259 kg) and the operator.
Using the dimensions shown in Fig. 2 as a guideline,
plan for placement within your shop that will allow the
operator to work unencumbered and unobstructed by
foot traffic (either passing shop visitors or other shop
workers) or other tools or machinery.
ESTABLISHING A SAFETY ZONE
For shops with frequent visitors or multiple operators, it is
advisable to establish a Safety Zone around shop machinery. A clearly defined "no-go" zone on the floor around
each machine can help avoid accidents that could cause injury to either the operator or the shop visitor. It is advis-
able to take a few moments to either paint (using non-slip paint) or using tape, define on the floor the limits or
perimeter of each machines safety zone. Take steps to ensure that all operators and shop visitors are aware that
these areas are off limits whenever a machine is running for everyone but the individual operating the unit.
ASSEMBLY INSTRUCTIONS
For your convenience this sander is shipped from the factory partially assembled and requires only minimal assem-
bly and set up before being put into service.
Do not plug in or turn on the sander until you have completed the installation and assembly steps described in
this section of the manual.
INSTALL THE CONVEYOR TABLE ELEVATION CRANK HANDLE
1. Install the conveyor table adjustment crank han-
dle, , on the shaft located on the top left end of
the sander . The slots in the crank handle must be
aligned with the spring pin on the shaft,
Fig. 2
2. Screw the knob,
crank handle.
.
, into the threaded hole in the
7