General 15-150 Setup And Operation Manual page 11

SWITCHES OFF
1. Set both of the power switches on the sander to the
off position , , and disconnect the machine from
the power source ,
.
Note: If the sander is permanently connected to a cir-
cuit (hard-wired), set the wall panel circuit breaker or
main circuit interrupter to the off position.
3. Press the blue reset button ,
RAISING/LOWERING THE CONVEYOR TABLE RAISING/LOWERING THE CONVEYOR TABLE
The conveyor table can be raised or lowered ,
crank handle , . (Fig. 3)
Note: The maximum workpiece thickness capacity for this machine is 5" .
UP
DOWN
Fig. 3
1. Put the workpiece on the conveyor belt.
Never attempt to sand workpieces that are greater
than 5".
2. Unscrew the 2 screws ,
.
, as needed to suit the thickness of the workpiece, by rotating the
box front cover .
4. Reinstall and rescrew the control box cover.
5. Reconnect the sander to the power source.
6. You can now restart the drum motor by pushing on
the green button ON.
,
Note: The depth gauge, on the front of the machine can be
used as a reference but it is not intended for high precision
measurements.
DO NOT
* Effect exaggerated for clarity
2. Set the height of the conveyor table so that the work-
piece barely touches the front drum ,
Note: To avoid overworking the motor, creating a potential
circuit overload, or damaging the sanding drums, do not
force the workpiece against or into the drums.
, and remove the control
DO
DRUM
WORK PIECE
CONVEYOR BELT
.
11