Table of Contents
Advertisement
LUBRICATION
Disconnect machine from power source, before performing any maintenance or lubrication.
Note: Unscrew and remove both left and right cover to access
the conveyor elevation mechanism.
Keep threaded rods,
Clean and remove dust, debris, and old grease after every 10-15 hours of use. After cleaning, re-apply a generous
coating of any common automotive bearing grease. (Fig. 8)
PERIODIC MAINTENANCE
1. Inspect/test the ON/OFF switches before each use. Do not operate the sander with a damaged switch; replace
a damaged switch immediately.
2. Keep the machine, especially motor and conveyor, as well as the feed table conveyor clean and free of dust
or glue. Vacuum or brush off any loose debris and wipe down the machine and the conveyor occasionally
with a damp rag.
3. The drums must always be kept clean. Dirt on the drums will cause belt slippage.
4. The motor and drum bearings are sealed and permanently lubricated – no further lubrication is required.
5. Periodically inspect the power cord and plug for damage, as well as the sanding belts, the drums, the motor
pulleys, drive belts and the conveyor belt.
Never operate the sander with any damaged part. Replace a damaged part at the first visible signs of damage.
REQUIRED MAINTENANCE
MOUNTING AND REPLACING THE SANDING BELTS
Sanding belts should be replaced when worn out.
Pre-cut replacement belts can be purchased in a variety of grits from your General® International dealer under the
following parts numbers:
16
, and gears,
, located at either end of the machine greased and free of dust or debris.
• 36 grit - 15-251
• 60 grit - 15-252
• 80 grit - 15-253
• 100 grit - 15-254
Fig. 8
• 120 grit - 15-255
• 150 grit - 15-256
• 180 grit - 15-257
• 220 grit - 15-258
Hide quick links:
Advertisement
Table of Contents
