Caring For The Appliance After Use; Retractable Cord Section; To Reset The Iron; Storing The Iron - Sunbeam Steam Master 4211 Instruction Manual

To reset the iron:

Move the iron back and forth and allow it to reheat for 2 minutes. The indicator will stop
blinking and the iron will start heating again.
WARNING: The patented MOTION SMART
means for turning your iron off. See "Caring for Your Iron After Use" for information on
turning off your iron and storing it safely between use.
A -C
NTI ALCIUM
The Anti-Calcium System is a permanent system located inside the water reservoir.
This system removes calcium from the water and reduces calcium build-up on the soleplate.
R C
ETRACTABLE
1. When winding the cord, hold the plug with one hand, and press the winding button
with the other hand. (Failure to hold plug may cause plug to fly.)
2. The cord reel is compact for multi-layer winding of the cord. In case cord is not fully rewound,
pull out the cord and steer cord evenly on the reel.
3. In case the cord is not pulled out easily, pull cord firmly.
4. Select the amount of cord desired before plugging into an electrical outlet.
5. Do not allow children to use retractable cord feature as the cord may cause injury.
C
ARING FOR
T O
URNING FF
1. Turn the Steam Lever to
2. Unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron. This can damage the cord.
S Y
TORING OUR
1. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir after each use for
a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole
cover, and allow water to flow from the fill hole. Shake the iron gently to remove trapped
water drops.
3. On corded models only: Loosely loop the power cord around the heel rest and store the
the iron on its heel rest.
I : Wrapping the cord around the iron too tightly can damage the cord.
MPORTANT
T : When not ironing, always set the Steam Lever to
IP
to Off.
S
(select models only)
YSTEM
S
ORD ECTION
Y
Y I
OUR RON
O /Off (Dry) and Fabric Select Dial to Off.
I
RON
®
Auto-Off is a safety feature, not a recommended
(select models only)
I
OUR RON
O /Off (Dry) and the Fabric Select Dial
A U
FTER SE