HP ProLiant SL4545 G7 Maintenance And Service Manual page 44

Install all heatsinks.
9.
Install the DIMMs (on page 27).
10.
Install the processor air baffle (on page 28).
11.
Install the personality board assembly (on page 37).
12.
Install the access panel (on page 23).
13.
Install the node into the chassis
14.
Power up the node.
15.
After you replace the system board, you must re-enter the node serial number and the product ID.
During the node startup sequence, press the F9 key to access RBSU.
1.
Select the Advanced Options menu.
2.
Select Service Options.
3.
Select Serial Number. The following warnings appear:
4.
WARNING! WARNING! WARNING! The serial number is loaded into the system during
the manufacturing process and should NOT be modified. This option should only
be used by qualified service personnel. This value should always match the
serial number sticker located on the chassis.
Warning: The serial number should ONLY be modified by qualified service
personnel. This value should always match the serial number located on the
chassis.
Press the Enter key to clear the warning.
5.
Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID on the chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
("Installing a node into the chassis" on page 22).
Removal and replacement procedures 44