Cleaning And Care - Sunbeam BC1912G Owner's Manual

Caution: All cleaning and maintenance should be done when grill is cool and with the fuel supply turned off
at the LP cylinder. DO NOT clean any grill part in a self-cleaning oven. The extreme heat will damage the
finish.
Cleaning – Burning-off the grill after every use (approx. 15 minutes) will keep excessive food residue from
building up.
Recommended cleaning materials -
Mild dishwashing liquid detergent
Nylon cleaning pad
Paper clip
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces - Use mild dishwashing detergent and hot water solution. Non abrasive scouring powder can
be used on stubborn stains, then rinse with water.
If the inside surface of the grill lid has the appearance of peeling paint, baked on grease buildup has turned
to carbon and is flaking off. Clean thoroughly with strong solution of detergent and hot water. Rinse with
water and allow to completely dry. NEVER USE OVEN CLEANER.
Interior of grill bottom – Remove residue using brush, scraper and/or cleaning pad, then wash with
dishwashing detergent and hot water solution. Rinse with water and let thoroughly dry.
Plastic surfaces – Wash with a soft cloth and dishwashing detergent and hot water solution. Rinse with
water. Do not use abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts.
Cooking Grid – Use mild dishwashing detergent and hot water solution. Non abrasive scouring powder can
be used on stubborn stains, then rinse with water.
Heat Plate – Clean residue with wire brush and wash with soapy water, then rinse with water.
1. Turn gas off at the control knob and disconnect cylinder.
2. Remove cooking grate and heat plate.
3. Remove burner by unscrewing the regulator valve from burner inlet and removing the fastener securing
the burner to the grill bottom.
4. Lift burner up and away from gas valve area.
5. Clean inlet (venturi) of burner with small bottle brush or compressed air.
6. Remove all food residue and dirt on outside of burner surface.
7. Clean any clogged ports with heavy-duty pipe cleaner or a stiff wire (such as an opened paper clip)
8. Inspect burner for any damage (cracks or holes). If damage is found, replace with new burner.
Reinstall burner; check to insure that gas valve orifices are correctly positioned and secured inside burner
inlet (venturi).
BC1912G owner's manual
Model BC1912G Portable Gas Grill

Cleaning and Care

Hot water
Wire brush
Putty knife/scraper
CLEANING THE BURNER ASSEMBLY -
Owner's Manual,
9