Ac Power Connections; Analog & Serial Cable Connections; Operator Interfaces - Process Sensors MCT Series Installation And Operation Manual

Refer to Section 11.0
5. 1 AC Power Connection
The sensor is powered directly using the 6-foot (2mtrs) power cord provided. The input is auto ranging
and accepts 90-260VAC volts, 15 amps. It is recommended that the power be supplied via a breaker or
on/off switch mounted close to the sensor. An optional breaker switch is available from PSC.
5.2 Analog and Serial Cable Connections
Customer data cables connect to the sensor by two 6-way I/O connectors on the rear of the sensor.
Details of the respective terminals in these connectors are given in Section 11.0
5.3 Displays and Operator Interfaces
The MCT may be set-up by using several operator interface and display modules.
Wall Mountable:
The interface connects to the sensor using the 9 pin circular socket located on the rear of the sensor
housing.
Detailed descriptions of these interfaces are given in Sections 6.0 & 7.0
Host Computer:
The PC software program has its own Operation Manual.

6.0 Operator Interfaces

This display interface is designed to be permanently connected
to the sensor. It connects using a cable up to 500 feet (150
meters) in length.
This interface is a PC program designed to allow access to
an individual sensors internal setup and calibration settings.
It connects to the serial port of the sensor.
4