Install Hood - Broan Allure QS1 Series Instructions Manual

INSTALL HOOD

1 Hang hood from (4) Mounting Screws (from parts bag).
Slide hood towards wall until mounting screws are engaged
in narrow end of (4) Keyholes. Tighten mounting screws
securely.
CAUTION DO NOT PUSH ON FAN BLADE. Pushing on the
blade may cause it to interfere with other hood
parts.
2 Connect ductwork to hood. Use Duct Tape to make joints
secure and air tight.
3 Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2)
R16, 40 W Maximum Incandescent Bulbs. Purchase bulbs
separately.
!
CAUTION: Bulbs may be hot! Refer to bulb packaging
for further information.
4 Replace fi lters and make sure fan blade turns freely. Turn on
power at service panel, and test for proper operation.
NON-DUCTED FILTERS
If hood is to be installed Non-Ducted:
Purchase a set of (2) non-ducted fi lters from your local distributor
or retailer and attach them to the aluminum mesh fi lters.
KEYHOLE
OPERATION
(4)
MOUNTING
SCREW
(4)
HC0044
Fan:
Light: The 3-position rocker switch (on the right) controls the lights.
DUCT
TAPE
CLEANING
Aluminum mesh fi lters: Clean frequently using hot water and a
mild detergent. Filters are dishwasher safe.
Charcoal fi lters: Clean fi lter surfaces frequently with a damp cloth
and a mild detergent. DO NOT immerse fi lters in water or put in
dishwasher. The special "Clean Sense" feature indicates when
PAR20,
the fi lter is to be replaced. The blue and yellow strips will blend
50W MAX.
to green when it is time to change the fi lter. The "Clean Sense"
HALOGEN
feature works best when facing toward the cooking surface.
BULB (2)
To clean hood: Remove fi lters. Use a damp cloth and a mild
- -
OR
detergent to wipe all grease-laden surfaces. Use care when
R16,
cleaning fan blade — it must not become bent or misaligned. DO
40W MAX.
NOT ALLOW WATER TO ENTER MOTOR. Make sure all surfaces
INCANDESCENT
are completely dry before re-installing fi lters and restoring power.
BULB (2)
Motor is permanently lubricated. Do not oil or disassemble motor.
ALLURE
The 3-position rocker switch (on the left) controls the fan.
The left position is low speed, center position is off, and right
position is high speed. An indicator light shows that the
fan is on.
The left position is low light intensity, center position is off,
and right position is high light intensity.
WARNING: To reduce the risk of electric shock,
disconnect from power supply before cleaning.
®
QS1 SERIES
RANGE HOOD
Page 5