Table of Contents
Advertisement
10. TO CHANGE TOOLS
(1) Removing Face Mill or Drill Chuck Arbor
Loosen the arbor bolt (see fig. 4) at the top of the spindle shaft approximately 2 turns with a wrench.
Rap the top of the arbor bolt with a mallet. After taper has been broken loose, holding chuck arbor
on hand and turn detach the arbor bolt with the other hand.
(2) To Install Face Mill or Cutter Arbor
Insert cutter and cutter arbor into the taper of spindle. Tighten arbor bolt detach securely, but do not
over-tighten.
(2) Removing Taper Drills
(a) Turn down the arbor bolt and insert the taper drill into the spindle shaft.
(b) Turn the rapid down handle rod down until the oblong hole in the rack sleeve appears.
Line up this hole with the hole in the spindle. Insert key punch key through holes and strike
lightly with a mallet. This will force the taper drill out.
11. ORDERING REPLACEMENT PARTS
Complete parts list is attached. If parts are needed, contact your local distributor.
12. EXTRA TOOLING AND ACCESSORIES
Each of machines is equipped with a MT # 3 spindle taper or R8 spindle taper (examples below).
Contact your local distributor or a major cutting tool distributor to obtain any of these accessories.
Taper Drills
Reamers
End Mills
Cutter Arbor
Taps
Collets
Adapters and Sleeves
13. TAPPING EQUIPMENT
This machine can be equipped with an electric switch for tapping operation clockwise or
counter-clockwise, and the working depth also can be adjusted by the limit switch. (Electric switch will
be installed according to your requirement, and you must pay the cost only.)
OPERATION FOR TAPPING SWITCH: FOR CE EXECUTION:
(1) Turn the selection switch B (see Fig. 3) to "TAPPING" position (left) when you want to tapping
work.
(2) Turn the handle downwards for setting the stroke of tapping depth by graduated rod.
(3) Check the proper speed of spindle for spindle for your tapping condition.
13
Advertisement
Table of Contents
