Advertisement
5. OPERATION
5.1.
Press the on/off switch (fig.1) to switch on.
5.2.
To adjust the display brightness: use either the display increase increase or decrease buttons (fig.1).
5.3.
To turn the image back through 180° when using the mirror accessory, press the image flip button (fig.1).
5.4.
When not in use, switch the unit off using the on/off switch.
6. MAINTENANCE
6.1.
Before each use inspect the borescope to ensure that no damage is present, paying particular attention to the screen and probe.
6.2.
Clean the borescope regularly using a soft cloth and mild detergent, taking care not to exert excessive pressure on the screen.
DO NOT use solvent or abrasive cleaners.
6.3.
If the borescope is not to be used for a considerable time, the batteries should be removed to remove the risk of corrosion.
6.4.
When not in use, store in a dry, secure location out of reach of children.
7. TROUBLESHOOTING
Display is on, but does not
show image.
1) Display is dim, even at
maximum brightness.
2) Display turns itself off.
3) Camera does not turn on
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable) into
approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and
Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling information.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance
scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705
NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without
prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Problem
Possible Causes
1) Loose cable connection.
2) Probe head is dirty.
Low battery voltage
For battery removal see section 4.1.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Likely Solutions
1) Check cable connection.
2) Clean probe head.
Replace batteries
Environmental Protection
WEEE Regulations
Battery Removal
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
VS8196.V3 Issue: 1 - 30/03/17
Advertisement
