Sealey AUTO SERVICE VS819 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
! WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to
when using tools.
" DO NOT use the bore scope if damaged.
" DO NOT point the Distal Tip towards the sun, or view bright light sources. Permanent damage to your eye may
occur.
$ Maintainthe bore scope in good and clean condition for best and safest performance.
$ Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
$ A full range of personal safety equipment is available from your Sealey dealer.
$ Wear suitable clothing to avoid snagging. Do not wear jewellery and tie back long hair.
$ Account for all tools and parts being used and do not leave any in, or near, the engine.
$ Be alert to your surrounding environment while using the bore scope.
2. INTRODUCTION
Suitable for internal inspection of cylinder bores, engine components and other machinery/industrial applications.
Flexible 600mm shaft can be bent to shape to fit through small apertures and around obstacles. Subject illumination
is provided by two LEDs which are controlled by a three-position switch, giving low output, full output and Off. LEDs
are powered by 4 x AA batteries (supplied). Adjustable eyepiece allows user to tailor optics to suit their vision.
Supplied in a carrying case. There is also a mirror accessory supplied in a polypropylene container of 3 cms diameter
and 4 cms high. This accessory is shown in Fig 3 and connected to the bore scope in Fig 4.
3. SPECIFICATION
1 Model No: . . . . . . . . . . . . . . . . . . . .VS819
2 Shaft Length: . . . . . . . . . . . . . . . . .600mm
3 Probe Diameter: . . . . . . . . . . . . . . . .10mm
4 Viewing Angle: . . . . . . . . . . . . . . . . . . .40°
5 Viewing Distance: . . . . . . .10mm to infinity.
Fig 1
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
INSTRUCTIONS FOR:
BORE SCOPE (600MM)
VS819
MODEL NO:
6 Bending Diameter: . . . . . . . . . . . . . .76mm
7 Tip Diameter: . . . . . . . . . . . . . . . . . .10mm
8 Batteries: . . . . . . . . . . . . .4 x AA (supplied)
9 Housing Material: . . . . . . . . . . . . . .Nylon 6
10 Mirror Accessory . . . . . . . . . . . . . .VS819M
VS819 - 2 - 030206