Rear Panel - Bryston BDA-3.14 Owner's Manual

BALANCED BALANCED
SINGLE
ENDED
RIGHT
ANALOG OUTPUTS
10

Rear Panel

9. A/C Input
An IEC-320 C14 power inlet provides for
connection of an IEC-320 C13 equipped power
cord. Before connecting the power cord,
check that the voltage rating on the data plate
conforms with your locality. Upon applying
power, the BDA-3.14 will enter standby mode.
See "Connecting to A/C Power" on page 4.
10. Analog Outputs
Balanced and single ended analog output
are provided via respective left/right pairs of
XLR and RCA jacks. When using a separate
preamplifier, be sure to set the default volume
to 100%. When using the BDA-3.14 connected
directly to an amplifier, note that the default
startup volume is -60dB but can be changed in
the webUI Audio Devices settings menu.
11. Digital Audio Inputs
Four traditional digital inputs are provided to
receive audio from source components. Each
corresponds to a matching source selector
button on the front panel.
AES/EBU: 110Ω Balanced XLR
S/PDIF 1: 75Ω Coaxial RCA
S/PDIF 2: 75Ω Coaxial BNC
Toslink: Toslink Fiber Optic
12. USB Audio Inputs
Two "Type B" USB Class 2.0 Audio inputs are
available to receive audio from computers,
media servers or other compatible source
12
19
18
USB ACCESSORY
NO USER SERVICEABLE PARTS INSIDE
ACUNE PIECE REPARABLE L'UTILISATEUR
SINGLE
ENDED
LEFT
AES/EBU SPDIF 1 SPDIF 2
11
20
13
ETHERNET
HDMI 4 HDMI 3 HDMI 2
RS232
USB AUDIO 1 USB AUDIO 2
TOSLINK
12 15
components. See "USB Audio" on page 5.
13. HDMI Inputs
Four HDMI inputs are available. 1 through 3 are
each version 1.4a and HDCP version 2.0. Input 4
is HDCP 2.2 compliant. They may receive PCM or
DSD audio, but not surround formats. See "HDMI
Audio" on page 5.
14. HDMI Output
When an HDMI input is selected, the output will
pass video signals along to the next connected
HDMI receiver such as a television or surround
processor. See "HDMI Passthrough" on page 6.
15. Control Interfaces
Three two-way control interfaces are available
to enable BDA-3.14 control by home automation
systems. See "Remote Control" on page 16 for
connection diagrams and protocol details.
16. Trigger Input
Power/Standby can be toggled from a master
component such as a preamp using this input.
The connector is a standard 3.5mm tip sleeve
commonly referred to as a "mono mini plug".
Signal should be AC or DC between 3 and 12
volts. When voltage is present at the tip, the
BDA-3.14 will remain powered on. The BDA-3.14
powers off when voltage is removed.
17. Status LED
LED lights to indicate the following status:
Red: Standby
Amber: Starting up Blinking Amber: Updating firmware
Blue: Self programing. Do not power off
18. Data Plate
17
14
HDMI 1 HDMI OUT
B DA-3 1 4 . STR E AM E R | DAC
CANADA
MADE IN
FABRIQUE AU
SVC ETHERNET
USB
TRIGGER IN
STATUS
IEC 320-C14
POWER INLET
CONTROL
16
Green: On
9
PETERBOROUGH
ONTARIO