Atari Lynx FlashCard User Manual page 20

Error Messages and Common Problems
Message "Erase memory failed disconnect usb and try again" appears:
Just disconnect the USB-Cable and reconnect again after 5 seconds.
If that doesn't help, just do a "reset all" via the menu.
One or all "X"s are missing on the menu:
Do a "Reset All" and the "X"s should show up again.
Program not working after upload:
First, check the Card settings.
Is the Memory-scheme correct? Is the Memory Capacity correct? Is the file format set to
the correct value? Does the Lynx file work at all in an Emulator? (e.g Handy)?
Note: some of the demos you can find in the internet do not work on a Lynx system.
They only work with an Emulator.
Note: some .lnx-files do not have correct data in the header. This may cause problems
with the Auto Size mode.
The Card doesn't react any more:
Connect the FlashCard to USB. Press and hold "Anykey," then press "Reset." Hold for 1
second, then release "Reset" while still holding "Anykey." Wait 4 seconds until the Status-
LED turns green. Release "Anykey."
The card is then reset to the default Value of 9600 BAUD.
Note: If you continue to hold "Anykey" until the Status-LED turns from green, to red, to off,
you can then release the "Anykey" without having to reset the Baudrate or jump in the
Bootloader.
By pressing the "Reset" Key, the PC connection has been reset.
Seite - 20 -