Atari Lynx FlashCard User Manual page 19

Short introduction to HTerm
A few basic things about HTerm:
A - Sets how the data sent by the FlashCard is displayed.
B - Sets the format in which the data sent to the Card is displayed.
C - Sets the format of the input data.
D - Selects which data to send. (Push this button after selecting "W" to write to FlashCard)
E - Sets the COM-Port the PC assigned to the Card. *
F - Sets the Baudrate.
G - Connects the Card to the Terminal. Press "Disconnect" to close the connection
between the Card and the Terminal.
H - Set Newline to "CR+LF"
* In case you don't know which COM port to use, you can find out by starting HTerm
without connecting the Card via USB. Select the Drop-Down list, and see which ports
exist.Then connect the Card, and after the OS recognizes it, click the "R" Button and
consult the Drop-Down menu again to see the added COM-Port.
Note: If you unplug the FlashCard from the computer's USB port, you will need to press
"Disconnect" in HTerm, and when plugging the FlashCard back into the computer, you will
need to press "Connect" in HTerm before you can use the Card. This is because HTerm
can not detect if the FlashCard has been removed.
Seite - 19 -