Table of Contents
Advertisement
Initial Operation
Connect the FlashCard to your PC by using the provided USB cable.
Caution! Using a USB-Hub can cause malfunctions and/or connection-terminations.
The operating system should automatically detect the device and install the needed USB
drivers. Should the operating system not be able to find those drivers, you can get them
from the FTDI homepage.
The FlashCard's factory setting for baudrate is 9600 baud. The FlashCard can use
baudrates up to 115200. To change baudrate, see page 11.
Note - If you update the firmware or reset your FlashCard, it will reset to 9600 baud.
Seite - 10 -
Advertisement
Table of Contents
