LG WV5-1275W Owner's Manual page 14

Checking the Rubber Seal on the
Water Inlet Hose
Two rubber seals are supplied with the water inlet
hoses. They are used for preventing water leaks.
Ensure the washers are in place before connecting
the inlet hose. Make sure the connection to taps is
sufficiently tight. Do not use any mechanical device
to overtighten the inlet hoses. Hand tighten only
with the aid of a soft cloth if necessary. After both
ends have been connected, open the taps slowly
and check for leaks. The curved end of the inlet
hose must be connected to the machine.
Connecting Hose to Water Tap
(Each country's methods of connection will vary.
Refer to the appropriate type below.)
Connecting Screw-Type Hose to a Tap
with a Thread
Screw the hose connection to a water supply tap
, which has a ¾" threaded union. Use the straight
end of the hose to connect to the tap. Connect the
curved end of the hose to the machine.
14
NOTE
• Before connecting the inlet hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.
Connecting Screw-Type Hose to Tap
Without Thread
1
Loose the four fixing screws.
Upper
connector
Fixing screw
2
Remove the guide plate if the tap is too large to
fit the adapter.
Guide plate
3
Push the adapter onto the end of the tap so that
the rubber seal forms a watertight connection.
Tighten the four fixing screws.
EN
Rubber
seal