Tripp Lite B126-2P2M-POC Owner's Manual page 5

Extender Kit Installation
4. Using a Cat5e/6/6a cable, connect the OUTPUT 1 port on the transmitter
unit to the RJ45 port on a receiver unit. The green RJ45 LED on the
receiver unit will illuminate to indicate the unit is receiving power. The
orange RJ45 LED will also illuminate to indicate the unit is connected to a
powered-on transmitter.
5. Repeat step 4 to connect the transmitter unit's OUTPUT 2 port to the
additional receiver unit.
6. Connect the receiver unit's HDMI connector to the monitor's HDMI port.
7. Repeat step 6 to connect the additional remote unit to an additional
HDMI monitor.
8. Turn on the power to the HDMI source. The orange RJ45 LEDs on the
transmitter unit will illuminate to indicate a signal is being received from
the source. The source image should now display on the connected
monitors.
Note: The transmitter unit's external power supply provides sufficient power for most
displays. However, in the event additional power is needed, a USB Micro-B port is
provided on the Receiver units. If no image displays after following the installation
instructions, use the included USB Micro-B cables to connect the receivers to the
monitor's USB port or a USB wall charger.
17-01-159-9336A2.indb 5
5
2/16/2017 8:53:35 AM