Attach The Wall Plate To The Wall - GABOR TM-3255 User Manual

ATTACH THE WALL PLATE TO THE WALL

Wood Stud Installation
1. Use a stud finder to
locate the studs in your
wall, and mark the
locations with a pencil.
Note: It's important to find
both edges of the stud, so
you can drill a pilot hole in
the center of the stud.
8 Installation Instructions
2. Place the wall mount over
your pencil marks. Use
the included leveler to
make sure the wall mount
is straight. Mark the
appropriate wall mount
holes with a pencil.
3. Use a
3/16 in. (4.5 mm)
drill holes
drill bit, and
approximately 2.2 in.
(55 mm) deep into
the studs.
4. Attach the wall mount
to the wall with screws
(I) and washers (K) until
mount is held in place, but
do not completely tighten
the screws.
Important! Do not use wall
anchors when installing the
wall mount onto wood studs.