6
Maintenance
9. Make sure the electrodes are in the correct position.
Fig. 6-11 Step 9 - Replace wear parts on the pilot burner
10. Mount the outer tube again and perform electrode test, see chapter 5.2 Assembly check
ionisation electrode.
Mount the device again
Procedure:
1
2
3
4
5
Ignition electrode (short): left
ionisation electrode (long): right
Re-tighten all hexagon screws.
Install the pilot burner again, see also chapter 5.2 Assembly
Connect gas and air supply again.
Connect electrical connections again.
Perform leak test, see also chapter 5 Commissioning
Perform functional test, see also chapter 5 Commissioning
55