Connecting The Condensate Drain - Floor-Standing And Floor-Standing Flat Installation - BPC DUPLEX 250 Easy Use, Maintenance And Installation Manual

Connecting the condensate drain – floor-standing and floor-standing flat installation
6.8.
When the unit is to be installed in a floor-standing or floor-standing flat position, a condensate drain must be first prepared using
the bushing provided and silicon. All this must be done before putting the unit into operation; the equipment must be disconnected
from power supply.
To install the condensate drain use only the points provided on the units in the form of visible recesses.
Holes for the fitting kit are provided and needn't be cut out - just push out the plug being pushed out.
Fitting the bushing into the unit's enclosure

Fitting
The point designed to fit the condensate drain with
accessories
Insert the bushing, with the flange on the inside of
the unit
Fitting the line on the sleeve

A condensate drain from the bottom of
the unit – use the shorter tube first
Push out the middle part of the hole
using just your finger – the hole
below the outlines of the smaller hole
Put on a washer from the other side
and tighten with a nut – tightening to
be done only by hand
Direct / elbow condensate drain connection
for inserting the line
18
Remove the plug
Insert the line and secure it with
a clip (the clip is provided by the
plumbing installation company)