Travis Industries DaVinci Manual page 4

Re-Routing the Heat Exchanger Inlet(s) Upwards

The inlets are shipped in the downward positon. One or both inlets may be re-routed upwards.

Remove the 4 screws holding the cover plate and gasket in place.

Remove the corresponding inlet and gasket and re-connect with the 4 screws in the desired position.

Re-connect the cover plate and gasket with the 4 screws in the desired position.
NOTE: Cover plate and inlet are positioned with the notches to the side (they will not install if rotated 90°).
Page 4 of 10
DaVinci Heat Exchanger
Touch-Screen Version
17601915 - 12/20/17 Travis Industries, Inc.