Advertisement
Installation Overview
The overview below details installation concerns for the type of heater being used. Install
the heat duct prior to installing drywall. The homeowner must turn the blower on and off
manually. The blower will remain on until the fireplace is turned off.
Heat Outlet Boot and Register
- register has direction vane
- make sure register is not shut off
(knurled knob to the side of louvers)
- should be raised above flooring material
to allow register installation.
Page 2 of 10
DaVinci Heat Exchanger
Touch-Screen Version
MIN. 1" CLEARANCE REQUIRED TO HEAT EXCHANGER BOX
This clearance is to top, sides, and bottom of the box. The duct has a 0" clearance.
Heat Exchanger Inlets
- orientation does not matter
- may be re-routed to the top
4" Diameter Duct (insulated - 0" clearance)
- maximum 50' (15M) combined length
17601915 - 12/20/17
Power for Blower
- Power for the blower comes from the
fireplace and is controlled by the touch
screen.
- A 120v power line is routed to the
fireplace (not supplied - use romex, etc.).
Blower Box
- raise 1.5" minimum if placing near floor
- must not be placed on its side
- must draw air from inside the
household/structure (do not pull from
an exterior location).
- includes grill and optional filter
Travis Industries, Inc.
Advertisement
