ALL Fostoria YES models require some assembly. Four steps are required to complete the assembly and installation.
Tools required: (2) ¾" socket or box wrenches.
Parts required: the two screws required to secure wall/ceiling
bracket to a suitable surface are not supplied with heater. You must
use 5/16" bolts and flat washers to mount this bracket.
Hanger Assembly Detail
HANGER
RUBBER
WASHER
FALLING OBJECTS HAZARD
CHUTES D'OBJETS LES RISQUES
•
Serious injury or death may occur.
Blessures graves ou la mort peuvent
survenir.
•
Read and follow all safety information
and
Lire et suivre toutes les consignes de
sécurité et les instructions dans la boîte
ci-dessous.
Mounting bracket supplied with YES models MUST
•
be used to support heater.
Installer MUST be certain surface that bracket
•
is mounted to will support 100 lbs of weight
continuously.
Rotating stops MUST be installed as shown above.
•
Do not mount heater upside down (See nameplate
•
label for "TOP" of heater.)
The bottom of these units must be mounted at
•
least 6 ft. off the floor and the top 2 ft. from the
ceiling.
•
Do not suspend ANY other equipment from this
bracket. One heater per bracket
Issue Date: 4-19-02
Rev. Date: 10/18
YES - SERIES INSTALLATION
STEEL
ROTATING
WASHER
STOP
BAR
KNOB
FIRE HAZARD
RISQUE D'INCENDIE
instructions
in
box
Rev. Level: 21
Step 1: Install (1) side rotating stop over bolt
and into curved slot (as shown at right) on
each side of heater.
Step 2: Assemble hanger to heater per
hanger assembly detail. No tools are required.
Step 3: Secure wall/ceiling mounting bracket
to appropriate surface that will support a min.
weight of 100lbs continuously. NOTE: all mounting hardware to
mount hanger to wall/ceiling bracket is supplied with heater.
Step 4: Assemble unit to mounting bracket following instructions
of chosen mounting option below.
BOLT
STEEL
WASHER
NYLON
WASHER
Wall Mount Option #1
ROTATING
STOP
below.
TOP OF HEATER
STEEL
WASHER
ECO1-7476
Ceiling Mount Option
ROTATING
STOP
BOLT
STEEL
WASHER
NYLON
WASHER
.
Wall Mount Option #2
BOLT
NYLON
WASHER
STEEL
WASHER
NUT
OIPM P/N 8997
STEEL
WASHER
NUT
STEEL
WASHER
NUT
4 OF 14