Top surface
❼
Securely attach head support rod to the table until it goes no further.
7)
Fix hinge stopper with screws . At this time, be sure to adjust so that the end face of hinge is spaced
8)
45 mm from the end face of hinge stopper .
Multi-layered part
❾
– 5 –
Attach a filter ❾ to the oil pan ❼ as shown in the
5)
figure.
Install filter ❾ so that its multi-layered part is
brought to the right side as observed from you.
Install hinge on the bed with screw . Engage
6)
the hinge with the rubber hinge of the table. Then,
place the machine head on the machine head
support rubber.
Chamfered
section
Chamfered section