JUKI PLC-2700 Series Instruction Manual page 16

• CP-180
A
❽
❹
❶ ❷
B
❼
Simultaneously pressing switch ❶ and switch ❷,
1)
turn ON the power switch.
is displayed A in the indicator and the mode
2)
is changed over to the adjustment mode.
3) Turn the pulley of the machine head by hand until
the main-shaft reference signal is detected. At this
time, the degree of an angle from the main-shaft
reference signal is displayed on the indicator
B.
(The value is the reference value.)
In this state, align one of the marker dots ❼ on
4)
the pulley with marker line ❽ on the pulley cover
as shown in the figure.
Press switch ❹ to finish the adjustment work.
5)
(The value is the reference value.)
– 14 –