Grinding Disc Replacement; Maintenance And Repair; Spare Parts - Mahlkonig DK15 Series Operating Instructions Manual

I N D U S T R I E M Ü H L E N | I N D U S T R I A L G R I N D E R

10. Grinding Disc Replacement

If the grinding performance decreases and the ground products are hot
and irregular, you should change the grinding discs.
1. Take the grinder apart as described under "9" and remove the grind-
ing discs from the grinder casing and the pre-breaker using a screw-
driver.
2. Clean the surfaces of the new grinding discs thoroughly and screw
them in position tightly and evenly.
3. Close the grinder casing again as described under "9" and set the
grind degree again as described under "8".

11. Maintenance and Repair

Always pull the power supply plug out of the outlet
before carrying out any maintenance or cleaning
work on the device!
Check the device regularly for any signs of damage
on the power supply cable, plug, fi nger protector, etc.
Any repairs that may be required are only allowed to
be carried out by authorised experts. Please contact
an authorised customer service centre or your local
dealer.

12. Spare Parts

Spare parts are usually ordered from your customer service centre or
your local dealer. To ensure quick, correct processing of your order, the
following information is absolutely required:
1. Type designation and serial number of the grinder (on the rating
plate on the rear side of the grinder).
2. Color of the grinder
12