Functions - ABB PST Series Installation And Commissioning Manual

&KDSWHU 
)LHOGEXV FRPPXQLFDWLRQ RSWLRQ
100
  $6,
The AS-I protocol is a simple fieldbus protocol with a few
digital inputs and outputs. Through the outputs, the motor
can be started / stopped and an additional action can be
performed depending on the selected function on the
programmable input In0. The inputs correspond to the
programmable softstarter outputs (K4 - K6 and V7) where
status information can be acquired according to the set
function.
See Chapter 7 "Settings and configuration" for
programming the inputs / outputs.
Before the AS-I fieldbus can be put into operation, the
following parameters must be set in the softstarter:
• Parameter )LHOGEXV &WUO set to Yes
• Parameter )LHOGEXV 7\SH set to AS-I
:DUQLQJ
,I WKH PRWRU LV UXQQLQJ DQG WKH SDUDPHWHU )LHOGE &WUO LV
FKDQJHG IURP 1R WR <HV WKLV ZLOO VWRS WKH PRWRU ILHOGEXV
FRQWURO RYHUULGHV WKH SURJUDPPDEOH LQSXWV 
,I WKH PRWRU LV QRW UXQQLQJ DQG WKH SDUDPHWHU )LHOGE
&WUO LV FKDQJHG IURP <HV WR 1R WKLV PLJKW VWDUW WKH PRWRU
LI WKHUH LV D VWDUW VLJQDO SUHVHQW RQ WKH SURJUDPPDEOH
LQSXWV
For installation and commissioning of the AS-I fieldbus,
see document 2CDC191002D0202 available at
www.abb.com/lowvoltage
,I ,Q LV SURJUDPPHG DV HQDEOH LW PXVW DOZD\V EH VHW
WRJHWKHU ZLWK D VWDUW FRPPDQG
1SFC132003M0201