Mapping Address Mode - ABB -Welcome Manual

ABB-Welcome
4.2.2

Mapping address mode

The address of each button can be set disorderly one by one, such as button 1=001,
button 2=003, button 3=005, button 4=002 ...
start
1.Adjust rotary switches to 000
and hold any button for
programming mode (beep)
2. Adjust rotary switches to the required
value (like 003) and hold dedicated
button for at least 1~3s
prompt tone (beep)
continue to
program
3. Adjust rotary switches to X00
X=address of outdoor station and hold
any button for 3 s to exit programming
mode (double beep)
End
If the last two rotary switches are set to 00, the device will work in the mapping
addressing mode, otherwise, it will work in the physical addressing mode.
|
3 s to enter into
until hear the
Y
N
Operation
— 8 —