Sharp Carousel RK-42S24 Installation Instructions page 4

STEP 4 FRAME INSTALLATION
1. Place the oven adjacent to the wall or cabinet opening. Plug the POWER
SUPPLY CORD BOX ASSEMBLY cord into the electrical outlet.
2. Carefully guide the assembled oven into the prepared opening. Slide
the oven on the EXHAUST DUCT ASSEMBLY. See Sketch 6. Avoid
pinching the cord between the oven and the wall. Adjust the position of
the oven so that the feet of the oven are fitted into the recesses of the
EXHAUST DUCT ASSEMBLY. See Sketch 7.
3. Position the FRAME ASSEMBLY to be square with the oven. Carefully
place the FRAME ASSEMBLY on the oven. Check that it is level and
then secure with two SCREWS C. See Sketch 8.
4. Secure the bottom portion of the FRAME ASSEMBLY with the two
remaining SCREWS C. See Sketch 8.
OVEN
EXHAUST DUCT ASSEMBLY
Sketch 7
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-2135
POWER SUPPLY CORD BOX
ASSEMBLY
REAR DUCT ASSEMBLY
SCREW C
SCREW C
For any other assistance or information about this kit, please call
FOOT
RECESS
SCREW C
SCREW C
Sharp's Customer Assistance Center at
1-800-BE-SHARP (1-800-237-4277)
4
Sketch 6
Sketch 8
TINSEB279MRR0
Printed in U.S.A.