Resetting A Device's Wireless Settings; Operation And Testing - Kidde P4010LDCS-WCA User Manual

9.3 Resetting a Device's Wireless Settings

If you encounter an issue at any point during the wireless network setup process, you may reset the device
by following the directions below.
a. beGin reSet
Press and hold the button on the device for 8-9 seconds until you
hear 3 beeps. Release button. You will hear the words "Resetting
wireless settings."
b. concLUde reSet
Light ring will flash green once and then it will pulse red. You will hear
the words, "Ready to connect, follow quick start instructions."
•
Device has been reset.
•
See Section 9.1 to begin set-up of a new wireless alarm network,
or Section 9.2 for adding this device to an existing alarm network.
note:
If no further steps are taken within 15 minutes of resetting the unit's wireless settings, a voice
prompt "No devices found, not connected" will be heard once, and the wireless function will turn off. The
unit will then perform as a stand alone alarm. See Section 9.2 for adding this device to an existing alarm
network.

10. Operation and Testing

oPeration
The alarm is operating once it is activated and testing is complete. When products of combustion (smoke) are
sensed, the unit sounds a loud alarm with a voice message. See Sections 1 and 2 for alarm signal descriptions.
18
"Resetting
wireless
settings."
Figure 9.3-A
"Ready to
connect, follow
Quick Start
instructions."
Figure 9.3-B
Hold for
8-9 seconds