Advertisement
10. Heat the connection evenly with the torch until the heat
11. Insert the other end of the in-line fuse wire into
12. Insert the negative base wire into the heat-shrink end
8
TAC5378_LFL_VehicleInstall_Rev.indd 8
AWG butt connector. Insert the free end of the extended
primary wire into the same butt connector. Crimp these
connections with a #14 AWG crimp tool.
shrink tightens around the connection and the solder
inside the connection melts.
heat shrink end of the #14 AWG terminal connector
appropriate for the 12 volt connection point you selected
previously. Crimp the connection using the #14 AWG
crimp tool. Heat the connection until the heat shrink
tightens around the connection.
of the #18 AWG terminal connector appropriate for the
ground connection you selected previously. Crimp the
connection using the #18 AWG crimp tool. Heat the
connection until the heat shrink tightens around the
connection.
a. If the base will be located further from the ground
connection than the factory base wire will allow, you
will need to connect an appropriate length of #14 AWG
primary wire to the negative base wire using a #14 AWG
to #18 AWG step-down butt connector. Crimp and heat
this connection until the heat shrink has closed around
5.11 Light For Life
Hardwiring Instructions
®
9/3/10 10:58 AM
Advertisement
