Table of Contents
Advertisement
12.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The turnspit does not ro‐
tate.
The display shows F111.
The display shows an error
code that is not in this ta‐
ble.
Steam and condensation
settle on the food and in
the cavity of the oven.
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
on.
The Child Lock is on.
The door is not closed cor‐
rectly.
The fuse is blown.
The lamp is defective.
The turnspit is not correctly
installed into the turnspit
hole.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the
oven for too long.
ENGLISH
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Turn on the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Refer to "Using the turn‐
spit".
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Turn off the oven with
the house fuse or the
safety switch in the fuse
box and turn it on again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
21
Advertisement
Table of Contents
