Safety Notice - Baldor 5 Series Installation And Operating Manual

SAFETY NOTICE

A Warning statement indicates a potentially hazardous situation which, if not avoided, could result
in injury or death.
A Caution statement indicates a potentially hazardous situation which, if not avoided, could result
in damage to property.
A Note indicates additional information that is not critical to the installation or operation.
WARNING! This equipment may contain voltages as high as 1000 volts! Electrical
shock can cause serious or fatal injury. Only qualified personnel should attempt the
start-up procedure or troubleshoot this equipment.
WARNING! Electrical shock can cause serious or fatal injury. Be sure that all power is
disconnected from drive before the finger-safe cover is removed. Removal of the
finger safe cover is required to make installation connections. Electrical shock can cause
serious or fatal injury if the finger-safe cover is removed and power is still applied.
WARNING! Electrical shock can cause serious or fatal injury. Verify there is no volt-
age phase-to-phase or phase-to-neutral at the AC Line Conductors before touching
the AC Input wires. Do not touch live wires, all power must be disconnected before proceeding.
WARNING! It is the responsibility of the equipment manufacturer and individual
installer to supply this Safety Warning to the ultimate end user of this product.
(SW/FSC 5/2005) Be sure to follow all instructions carefully. Fire and/or electrocution can result
due to improper use of this product.
WARNING! Do not use this drive in an explosive environment. An explosion can
cause serious or fatal injury. This drive is not explosion proof.
CAUTION!
Disconnect motor leads (U, V and W) from control before performing a "Leakage
Resistance" test on the motor. Failure to disconnect motor from the control may result in
extensive damage to the control. The control is tested at the factory for high voltage / leak-
age resistance as part of Underwriters Laboratories requirements.
CAUTION!
Suitable for use on a circuit capable of delivering not more than 5,000 RMS symmetrical
short circuit amperes listed here at rated voltage.
CAUTION!
Proper shielding, grounding, and filtering of this product can reduce the emission of radio
frequency interference (RFI) which may adversely affect sensitive electronic equipment.
7