Janome MS 2028 Instruction Book page 13

. Bobbin Windins
@ For horizontal spool pin
@ For additional spool pin
O Pullthe handwheel out to the right.
@ Draw thread from the spool.
O Guide the thread around the thread guide.
@ Thread through the hole in the bobbin from the
inside to the outside.
@ Put the bobbin on the bobbin winder spindle.
@ Push the bobbin to the right.
O With free end of the thread held in your nano,
depress the foot control. Stop the machine
when it has made a few turns and cut the thread
close to the hole in the bobbin.
@ Depress the foot control again. When the bobbin
is fully wound, it stops automatically. Return the
bobbin winde|to its original position by moving
the spindle to the left and cut the thread as
shown.
@ Push the handwheel in. The machine will not
function untilthe clutch is engaged.
NOTE: Position of lhe bobbin winder stopper is
adjustable for the required amount of
thread on the bobbin (example 1/2 full or
fulletc.).
Use a screwdriver and loosen the screw
one turn or less so that you can adjust the
position of the bobbin winder stopper.
Do not lake out the screw all the way.
at
ai
i ,6\
J F-\-'
l4r ls)
i\
?<
-se9
@
----=Tt
ll
- 1
t l
(\I---R
1 1